Yamatake SDC35, User Manual

Page: 143 / 280

5-85
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION
5 - 11 Continuous Output
The following shows the functional block diagram of the continuous output:
■
Output range
The output range of the current output and continuous voltage output can be set.
• When the object control output is the current output or continuous voltage
output, the display and setting can be configured.
■
Output type
The output type of the current output and continuous voltage output can be set.
• When the object control output is the current output or continuous voltage
output, the display and setting can be configured.
• MV scalable bandwidth is used to calculate SP+PV and PV+MV. For details,
refer to MV scaling range (on page 5-87).
• If ROM version 1 of the instrument information bank is prior to 2.04, SP+MV
and PV+MV cannot be selected.
(Setting: Setup C42, C47, C52)
Continuous output (current output/
continuous voltage output)
Output range type
(Setting: Setup C43, C48, C53)
Output type
(Setting: C44, C45, C49, C50,
C54, C55)
Output scaling high limit/low limit
Item (Bank) Display Contents Initial value User level
Control output 1 range
(Setup bank) Current output
1: 4 to 20mA
2: 0 to 20mA 1 Basic,
Standard,
High function
Control output 2 range
(Setup bank) 1
Item (Bank) Display Contents Initial value User level
Control output 1 type
(Setup bank) 0: Manipulated variable (MV)
1: Heat MV (for heat/cool control)
2: Cool MV (for heat/cool control)
3: PV
4: PV before ratio, bias, and filter
5: SP
6: Deviation (PV-SP)
7: CT1 current value
8: CT2 current value
9: MFB (including estimated MFB)
10: SP+MV
11: PV+MV 0 Basic,
Standard,
High function
Control output 2 type
(Setup bank) 3
Auxiliary output range
(Setup bank) 1
Continuous voltage output
1: 1 to 5V
2: 0 to 5V
3: 0 to 10V
Auxiliary output type
(Setup bank) 3