Instrument and control functions
4-6
1
2
3
4
5
6
7
8
9
10
11
12
13
14
3000 km (1800 mi) thereafter.
Clock
The clock uses a 12-hour time system.
To set the clock:
1. Set the display to “ODO”, then
press the “RESET” button for at
least three seconds.
2. When the hour digits start flashing,
push the “SELECT” button to set
the hours.
3. Push the “RESET” button, and the
first minute digit will start flashing.
4. Push the “SELECT” button to set
the first minute digit.
5. Push the “RESET” button and the
second minute digit will start flash-
ing.
6. Push the “SELECT” button to set
the second minute digit.
7. Push the “RESET” button to start
the clock.
TIP
If you do not push the “SELECT” or the
“RESET” button within 30 seconds, the
setting of the clock will not be complet-
ed and the display will change to “ODO”
mode.
EAU1234M
Handlebar switches
Left
Right
EAU12402
Dimmer switch “
/
”
Set this switch to “
” for the high
beam and to “
” for the low beam.
EAU12461
Turn signal switch “
/
”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “
”. When re-
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
1. Dimmer switch “
/
”
2. Turn signal switch “
/
”
3. Horn switch “
”
1. Engine stop switch “
/
”
2. Start switch “
”
1
2
3
1
2
BC9-9-14E0.book 6 ページ ２０１９年５月８日 水曜日 午後１時２２分
