Instrument and control functions
4-12
4
Right
EAU12352
Pass switch “
”
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to “
”, the passing switch has no ef-
fect.
EAU12402
Dimmer switch “
/
”
Set this switch to “
” for the high
beam and to “
” for the low beam.
EAU12461
Turn signal switch “
/
”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “
”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12501
Horn switch “
”
Press this switch to sound the horn.
EAU12664
Engine stop switch “
/
”
Set this switch to “
” (run) before
starting the engine. Set this switch
to “
” (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
EAU12713
Start switch “
”
Push this switch to crank the engine
with the starter. See page 6-2 for start-
ing instructions prior to starting the en-
gine.
EAU88273
Hazard switch “OFF/
”
Use this switch to turn on the hazard
lights (simultaneous flashing of all turn
signal lights). The hazard lights are
used in case of an emergency or to
warn other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
The hazard lights can be turned on or
off only when the main switch is in the
“ON” position. You can turn the main
switch to the “OFF” or “LOCK” posi-
tion, and the hazard lights will continue
to flash. To turn off the hazard lights,
turn the main switch to the “ON” posi-
tion and operate the hazard switch
again.
NOTICE
ECA10062
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
1. Engine stop switch “
/
”
2. Hazard switch “OFF/
”
3. Start switch “
”
1
1
1
2
3
2
3
UBEB20E0.book Page 12 Monday, September 6, 2021 11:24 AM
