Yamaha YZF155, Owner'S Manual

Page: 33 / 98

Instrument an d control functions
5-12
5
EAU1234R
Han d le b ar switches
Left
Ri g ht
EAU54203
Dimmer/Pass switch “ / /PASS”
Set this switch to “ ” for the high
beam and to “ ” for the low beam.
To flash the high beam, push the
switch down towards “PASS” while the
headlights are on low beam.
EAU12461
Turn si g nal switch “ / ”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “ ”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12501
Horn switch “ ”
Press this switch to sound the horn.
EAU12664
En g ine stop switch “ / ”
Set this switch to “ ” (run) before
starting the engine. Set this switch
to “
” (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
EAU12713
Start switch “ ”
Push this switch to crank the engine
with the starter. See page 7-2 for start-
ing instructions prior to starting the en-
gine.
EAUU1021
Hazar d li g hts switch “ / ”
The hazard lights (simultaneous flash-
ing of all turn signal lights) are used in
case of an emergency, such as to warn
other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
Set this switch to “
” to turn on the
hazard lights. To turn off the hazard
lights, set the switch to “ ”.
NOTICE
ECA10062
Do not use the hazar d li g hts for an
exten d e d len g th of time with the en-
g ine not runnin g , otherwise the b at-
tery may d ischar g e.
1. Dimmer/Pass switch “ / /PASS”
2. Turn signal switch “ / ”
3. Horn switch “ ”
1. Engine stop switch “ / ”
2. Hazard switch “ / ”
3. Start switch “ ”
1
2
3
1
2
3
UBNCEYE0.book Page 12 Thursday, September 16, 2021 3:25 PM