Yamaha YXZ10YEXH, Owner'S Manual

Page: 165 / 218

8-29
8
8. Start the engine and drive the vehicle for
a few minutes to circulate the transmis-
sion oil.
9. Park the vehicle on a level surface, stop
the engine, and then check the transmis-
sion case for oil leakage.
TIP
If oil is leaking confirm that the transmission
oil filler cap is properly installed and then have
a Yamaha dealer check the transmission.
10. Check the transmission oil level and cor-
rect if necessary.
11. Install the panel.
EBU36050
Final gear oil
Check the oil level and change the final gear
oil at the intervals specified in the general
maintenance and lubrication chart.
Checking the final gear oil level
1. Park the vehicle on a level surface.
2. Remove the final gear oil filler bolt and its
gasket, and then check the oil level in the
final gear case. The oil level should be at
the brim of the filler hole.
3. If the oil is below the brim of the filler hole,
add sufficient oil of the recommended
type to raise it to the correct level.
NOTICE:
Be sure no foreign material
enters the final gear case.
[ECB00422]
1. Final gear oil
2. Gasket
3. Final gear oil filler bolt
4. Correct oil level
2
4
3 1
UB577AE0.book Page 29 Wednesday, June 8, 2016 9:35 AM