Firmware Update Procedure for YSP-3300/YSP-4300
Page.5 of 7
Update Procedure for YSP-4300
Requirements:
USB thumb drive (File system with FAT16 or FAT32 format)
Software file provided by YAMAHA,”YSP2012-xxxx.bin”.
CHECK THE FIRMWARE VERSION PRIOR TO THIS UPDATE
Confirm that the power of YSP is off. Press and hold the
[INPUT]
key on the YSP and
while holding that key, power on (press
[
]
from the remote controller/
[
]
on the
YSP).
“ADVANCED SETUP”
will appear on the front display. Then, press
[UP]/[DOWN]
key to display
“FW UPDATE”
. After pressing
[ENTER]
or
[RIGHT]
key on the remote
controller, current version will be shown on the front display. If the firmware version is
already up-to-date, it is not perform the update.
There are
2 different firmware
prepared for the best your YSP performance.
1. YSP2012-0020.bin
Use this firmware, if current firmware version is
09
.XX.XX
*
or less (08, 07, ...)
.
New firmware version will be
12.04.05
after the update.
2. YSP2012-0018.bin
Use this firmware, if current firmware version is
10
.XX.XX
*
.
New firmware version will be
11.04.05
after the update.
(
*XX.XX
may have several variations)
If you are not able to perform the update, please make arrangements to deliver the unit to
an Authorized Yamaha Service Center and they will perform the update.
The following pages contain the procedures for this firmware update.
STEP 1
Copy the update file to a USB thumb drive
Unzip the downloaded file “YSP4300_Vxxxxx.zip”. The update file
“YSP2012-xxxx.bin” will appear. Copy to the root directory of a USB thumb
drive that supports USB mass storage class. (It is recommended to delete all
other files or folders.)
STEP 2
Insert the USB thumb drive
