Yamaha YS125-5C 2016, Owner'S Manual

Page: 27 / 90

Instrument an d control functions
3-12
3

Align the appropriate notch in the
adjusting ring with the position in-
dicator on the shock absorber.

Use the screwdriver included in
the owner’s tool kit to make this
adjustment.
EAU15306
Si d estan d
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
EWA10242
The vehicle must not b e ri dd en with
the si d estan d d own, or if the si d e-
stan d cannot b e properly move d up
(or d oes not stay up), otherwise the
si d estan d coul d contact the g roun d
an d d istract the operator, resultin g
in a possi b le loss of control.
Yamaha’s i g nition circuit cut-off
system has b een d esi g ne d to assist
the operator in fulfillin g the respon-
si b ility of raisin g the si d estan d b e-
fore startin g off. Therefore, check
this system re g ularly an d have a
Yamaha d ealer repair it if it d oes not
function properly.
1. Spring preload adjusting ring
2. Position indicator
3. Screwdriver
Sprin g preloa d settin g :
Minimum (soft):
1
Standard:
2
Maximum (hard):
5
2
1
3
(a)
(b)
UBT4E0E0.book Page 12 Thursday, November 17, 2016 10:55 AM