En
12
CONNECTIONS
Connecting speakers
■
(U.S.A. and Canada models only)
Changing speaker impedance
This unit is configured for 8
Ω
speakers as the factory setting.
When connecting to 6
Ω
speakers, carry out the following
procedure to switch to 6
Ω
.
1
Switch this unit to the standby mode.
2
Press
A
while pressing and holding STRAIGHT on
the front panel.
Release the keys when “ADVANCED SETUP” is displayed on
the front panel display.
After approximately a few seconds, the top menu items are
displayed.
J
1
3
Check that “SP IMP.” is displayed on the front panel.
4
Press STRAIGHT repeatedly to select a “6
Ω
MIN.”
5
Switch this unit to the standby mode, and then
switch it on again.
The power turns on, when the settings you made has been
configured.
■
Connecting speakers
1
Remove approximately 10 mm of insulation from the
ends of the speaker cables, and twist the bare wires
of the cables together firmly so that they will not
cause short circuits.
2
Loosen the speaker terminals.
3
Insert the bare wire of the speaker cable into the gap
on the side of the terminal.
4
Tighten the terminal.
PHONES
SILENT CINEMA
TONE CONTROL
STRAIGHT
TV
BD
DVD
CD
RADIO
INPUT
PROGRAM
SCENE
INFO
MEMORY
PRESET
FM
AM
YPAO MIC
STRAIGHT
PROGRAM
l
/
h
A
SPIMP.-8MIN
FR
ONT
2
2
3
1
4
4
Connecting the banana plug (Except U.K., Europe,
Asia and Korea models)
Tighten the knob, and then insert the banana plug into the end of
the terminal.
FR
ONT
Banana plug
J
J
1 :
Refer to the “Extended functionality that can be configured as needed
(Advanced Setup menu)” (
) for details on the Advanced Setup menu.
