8-32
8
8. After draining the coolant, thoroughly flush
the cooling system with clean tap water.
9. Install the coolant drain bolt and its new gas-
ket, and then tighten the bolt to the specified
torque.
10. Connect the coolant reservoir hose.
11. Pour the recommended coolant into the res-
ervoir to the maximum level mark, and then
install the reservoir cap.
12. Pour the recommended coolant into the radi-
ator until it is full, and then install the radiator
cap.
13. Start the engine, let it idle for several minutes,
and then turn it off.
TIP
While the engine is idling, check the cooling sys-
tem for leaks.
14. When the engine is cool, remove the radiator
cap to check the coolant level in the radiator.
If it is low, add sufficient coolant until it reach-
es the top of the radiator, and then install the
radiator cap.
15. Install the panels and the front carrier.
EBU37113
Cleaning the air filter
The main air filter element and sub air filter ele-
ment should be cleaned every 20–40 hours of en-
gine operation. When servicing the air filter
elements, check the air filter case inlet for obstruc-
tions. Check the air filter case rubber joint to the
throttle body and the rubber joint manifold fittings
for an air-tight seal. Tighten all fittings securely to
avoid the possibility of unfiltered air entering the
engine.
1. Coolant reservoir hose
Tightening torque:
Coolant drain bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
1
UBB511E0.book Page 32 Monday, March 5, 2018 3:26 PM
