YDP-151/YDP-323
Keyboard Stand Assembly
35
ENGLISH
2-5
Securely tighten the screws on the top of B
that were attached in Step 2-2.
3.
Securely tighten the screws on C that
were attached in Step 1-3.
4.
Mount A.
CAUTION
• Fingers can become pinched between the main
unit and the rear or side panels, be extra careful
so as not to drop the main unit.
• Do not hold the keyboard in any position other
than the position shown in the illustration.
5.
Secure A.
5-1
Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2
Secure A by tightening the short screws
2
(6
×
16mm) from the front.
6.
Connect the pedal cord.
6-1
Insert the pedal cord plug to the pedal con-
nector from the rear.
6-2
Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
6-3
Use a vinyl tie to take up any slack in the
pedal cord.
R
L
2-2, 2-5
2-4
2-3
2-3
2-1
D
B
E
Place the bottom
ends of the rear
panel on each foot.
3
B
C
R
A
B
D
E
Be sure to place your hands at least
10 cm from either end of the main
unit when positioning it.
At least
10 cm
5-2
A
5-1
Projection
of A
AC INLET
PEDAL
6-1
6-3
6-2
33
