Yamaha YC Series, Owner'S Manual

Page: 22 / 76

Setting Up
YC61 Owner’s Manual
22
Power Supply
Connect the respective ends of the supplied AC power
cord in the following order. Make sure the [STANDBY/
ON] switch on the instrument is set to the STANDBY
position.
1.
Connect the supplied power cord to the
[AC IN] jack on the instrument’s rear panel.
2.
Connect the other end of the power cord to an
AC outlet.
NOTE
Follow this procedure in reverse order when disconnecting the
power cord.
WARNING
• Use only the AC power cord supplied with your
instrument. The use of an inappropriate replacement can
lead to overheatin
g or electric shock.
• The power cord supplied with your instrument must not
be used with other electrical equipment. Failure to
observe this precaution can result in dama
g e to the
equipment or fire.
• Make sure your instrument the volta g e requirement for
the country or re g ion in which it is bein g used.
CAUTION
The instrument remains char g ed and draws a small amount
of power even when the [STANDBY/ON] switch is set to the
STANDBY position. If you intend not to use it for an
extended period of time, therefore, make sure to unplu
g the
power cord from the wall outlet.
Connecting Speakers or
Headphones
Since the instrument has no built-in speakers, you will
need to monitor the sound of the instrument by using
external equipment. Connect a set of headphones,
monitor speakers, or other playback equipment as
illustrated below. When making connections, be sure
that your cables have the appropriate ratings.
Turning On and Off
Make sure the volume settings of the instrument and
external devices such as powered speakers are turned to
the minimum before turning the power on. When
connecting the instrument to monitor speakers, turn on
the power switch of each device in the following order.

Turning on
Turn the [MASTER VOLUME] knob of this instrument
to its minimum (left-most setting) → set the [STANDBY/
ON] switch to ON → turn the amplifier or speaker power
on.

Turning off
Turn the [MASTER VOLUME] knob of this instrument
to its minimum (left-most setting) → turn the amplifier
or speaker power off → set the [STANDBY/ON] switch
to STANDBY.
Setting Up
[AC IN] jack
Power cord (included)
Rear panel
Keyboard amplifier or monitor speaker
(left) (right)
Headphones
OUTPUT
[L/MONO] jack
OUTPUT
[R] jack
[PHONES] jack