Yamaha YAS-201, Owner'S Manual

Page: 12 / 100

10
En
Learning has
failed
Twice
Flashes
* Repeat from Step 3-1.
4
Make the sound bar learn the volume (+) operation.
4-1
Press VOLUME (+) on the front panel of the sound bar.
INPUT –
4-2
While pointing your TV remote control at the remote control sensor, hold down the
volume (+) key for more than 1 second twice or three times.
Result Bleep/buzzer Indicators
Successfully
learned
Once
Lights up
Learning has
failed
Twice
Flashes
* Repeat from Step 4-1.
5
Make the sound bar learn the power operation.
5-1
Press (power) on the front panel of the sound bar.
INPUT –
5-2
While pointing your TV remote control at the remote control sensor, hold down the
power key for more than 1 second twice or three times.
Result Bleep/buzzer Indicators
Successfully
learned
Once
Lights up
Learning has
failed
Twice
Flashes
* Repeat from Step 5-1.
6
To finish the learning mode, press LEARN or (power) on the supplied remote
control.
This completes the necessary settings. Now you can operate the sound bar with the TV remote
control’s power key or volume keys.
HINT
• The learning mode will be finished automatically if no operations are performed for 5 minutes.
• Set the TV volume to minimum. When you turn up the volume of the sound bar with the TV remote control, the
volume of the TV may be turned up at the same time. In this case, follow Step 3 in “Connections” (p.7) to change the
TV setting.
Settings
Controlling the sound bar with TV remote control
(TV remote control learning function)
You can use the TV remote control to turn on/off the sound bar or adjust its volume by having the
sound bar learn the TV remote control signals.
NOTE
• This function is available only when your TV remote control uses infrared signals.
• Depending on the installation conditions or settings of the sound bar, both the sound bar and TV will receive the TV
remote control signals and operate simultaneously.
1
Turn off the TV and sound bar.
2
Hold down LEARN on the supplied remote control for more than 3 seconds to
set the sound bar to the learning mode.
When the sound bar is in the learning mode, the indicators on the front panel flash as shown
below.
3
Make the sound bar learn the volume (–) operation.
3-1
Press VOLUME (–) on the front panel of the sound bar.
INPUT –
3-2
While pointing your TV remote control at the remote control sensor, hold down the
volume (–) key for more than 1 second twice or three times.
INPUT – TV BD/DVD YIT SURROUND CLEAR VOICE UNIVOLUME DTS
D
SUBWOOFER PL
VOL VOL VOL VOL VOL VOL VOL VOL
Approx. 30 cm (1 ft)
TV remote control
Hold down
(more than 1 second)
Release
(more than 1 second)
Hold down
(more than 1 second)
Release
(more than 1 second)
Result Bleep/buzzer Indicators
Successfully
learned
Once
Lights up