Yamaha XVS950CU 2014, Service Manual

Page: 218 / 580

REAR WHEEL
4-27
EAS22140
ASSEMBLING THE REAR WHEEL
NOTICE
ECA1XC1011
For ABS models
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
1. Install:
• Wheel bearings
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Install the new wheel bearing. (right side)
NOTICE
ECA1XC1027
Do not contact the wheel bearing inner race
“1” or balls “2”. Contact should be made
only with the outer race “3”.
TIP
Use a socket “4” that matches the diameter of
the wheel bearing outer race.
b. Install the spacer.
c. Install the new bearing. (left side)
TIP
Place a suitable washer “1” between the socket
“2” and the bearing so that both the inner race
“3” and outer race “4” are pressed at the same
time, and then press the bearing until the inner
race makes contact with the spacer “5”.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
• Rear wheel static balance
Refer to “ADJUSTING THE FRONT WHEEL
STATIC BALANCE” on page 4-16.
EAS28770
INSTALLING THE REAR WHEEL (REAR
BRAKE DISC)
1. Install: (for ABS models)
• Rear wheel sensor rotor
NOTICE
ECA1XC1007
Replace the wheel sensor rotor bolts with
new ones.
TIP
Install the wheel sensor rotor with the stamped
mark “1” facing outward.
2. Measure: (for ABS models)
• Wheel sensor rotor deflection
Out of specification
→
Correct the wheel sen-
sor rotor deflection or replace the wheel sen-
sor rotor.
Refer to “MAINTENANCE OF THE REAR
WHEEL SENSOR AND SENSOR ROTOR
(for ABS models)” on page 4-26.
New
T
R
.
.
Rear wheel sensor rotor bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
LOCTITE®
Wheel sensor rotor deflection
limit
0.25 mm (0.0098 in)
1