Yamaha XV250M1 2020, Owner'S Manual

Page: 75 / 98

Perio d ic maintenance an d a d justment
7-39
7
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
TIP
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
7. Remove the axle nut.
8. Pull the wheel axle out, and then
remove the wheel.
To install the rear wheel
1. Install the drive chain onto the rear
sprocket, and then install the
wheel by inserting the wheel axle
from the right side.
2. Install the brake rod into the brake
camshaft lever, and then install
the brake pedal free play adjusting
nut onto the brake rod.
3. Connect the brake torque rod to
the brake shoe plate by installing
the bolt and nut.
4. Install the axle nut.
5. Lower the rear wheel so that it is
on the ground, and then put the
sidestand down.
6. Tighten the brake torque rod nut
to the specified torque.
7. Check and adjust the drive chain
slack. (See page 7-25.)
8. Adjust the brake pedal free play.
(See page 7-21.)
WARNING
EWA10661
After a d justin g the b rake pe d al free
play, check the operation of the
b rake li g ht.
EAU25853
Trou b leshootin g
Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur
during operation. Any problem in the
fuel, compression, or ignition systems,
for example, can cause poor starting
and loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
WARNING
EWA15142
When checkin g the fuel system, d o
not smoke, an d make sure there are
no open flames or sparks in the ar-
ea, inclu
d in g pilot li g hts from water
Ti g htenin g torque:
Brake torque rod nut:
23 N·m (2.3 kgf·m, 17 lb·ft)
U46B1BE0.book Page 39 Monday, July 8, 2019 11:51 AM