Yamaha XV19SW 2006, Service Manual

Page: 114 / 145

CHASSIS
3-25
3. Remove:
• Muffler
Refer to “ENGINE REMOVAL” on page 5-1.
4. Adjust:
• Drive belt slack
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated.
a. Loosen the wheel axle nut “1”.
b. Loosen both locknuts “2”.
c. Turn both adjusting bolts “3” in direction “a” or
“b” until the specified drive belt slack is ob-
tained.
NOTE:
Using the alignment marks on each side of the
swingarm, make sure that both belt pullers are in
the same position for proper wheel alignment.
d. Tighten the locknuts to specification.
e. Tighten the rear wheel axle nut to specifica-
tion.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
5. Install:
• Muffler
Refer to “ENGINE REMOVAL” on page 5-1.
WARNING
EWA12800
Always use a new gasket.
EAS21510
CHECKING AND ADJUSTING THE
STEERING HEAD
1. Stand the vehicle on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
front wheel is elevated.
2. Check:
• Steering head
Grasp the bottom of the front fork legs and
gently rock the front fork.
Binding/looseness
→
Adjust the steering
head.
Direction “a”
Drive belt is tightened.
Direction “b”
Drive belt is loosened.
1
1
2
3
a
b
T
R
.
Locknut (drive belt adjusting
bolt)
16 Nm (1.6 m·kg, 11 ft·lb)
T
R
.
Rear wheel axle nut
150 Nm (15.0 m·kg, 110 ft·lb)