INSTRUMENT AND CONTROL FUNCTIONS
4-5
4
from that point. In that case, push
the “
” side of the “SELECT” switch to
switch the display between the various
tripmeter and odometer modes in the
following order:
F-TRIP
→
TRIP A
→
TRIP B
→
ODO
→
F-TRIP
TIP
Push the “
” side of the “SELECT”
switch to switch the display in the re-
verse order.
To reset a tripmeter, select it by push-
ing the “
” or “
” side of the “SE-
LECT” switch, and then push the
“RESET” switch for at least one sec-
ond. If you do not reset the fuel reserve
tripmeter manually, it will reset itself au-
tomatically, and the display will return
to the prior mode after refueling and
traveling 5 km (3 mi).
Clock
The clock displays when the key is
turned to “ON”.
To set the clock
1. Turn the key to “ON”.
2. Push the “
” side of the “SE-
LECT” switch and “RESET” switch
together for at least two seconds.
3. When the hour digits start flashing,
push the “
” or “
” side of the
“SELECT” switch to set the hours.
4. Push the “RESET” switch, and the
minute digits will start flashing.
5. Push the “
” or “
” side of the
“SELECT” switch to set the min-
utes.
6. Push the “RESET” switch and then
release it to start the clock.
Self-diagnosis device
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
If a problem is detected in any of those
circuits, the engine trouble warning light
will come on or flash and the display will
indicate an error code.
If the display indicates any error codes,
note the code number, and then have a
Yamaha dealer check the vehicle.
1. Clock
1
1. Error code display
1
U1BH10E0.book Page 5 Tuesday, December 8, 2009 4:47 PM
