Instrument an
d
control functions
3-21
3
EAU39612
A
d
justin
g
the hea
d
li
g
ht
b
eams
The headlight beam adjusting knobs
are used to raise or lower the height of
the headlight beams. It may be neces-
sary to adjust the headlight beams to
increase visibility and help prevent
blinding oncoming drivers when carry-
ing more or less load than usual. Obey
local laws and regulations when ad-
justing the headlights.
To raise the headlight beams, turn the
knobs in direction (a). To lower the
headlight beams, turn the knobs in di-
rection (b).
EAU45205
A
d
justin
g
the front fork
WARNING
EWA10181
Always a
d
just
b
oth fork le
g
s equally,
otherwise poor han
d
lin
g
an
d
loss of
sta
b
ility may result.
This front fork is equipped with re-
bound damping force adjusting screws
and compression damping force ad-
justing screws.
NOTICE
ECA10102
To avoi
d
d
ama
g
in
g
the mechanism,
d
o not attempt to turn
b
eyon
d
the
maximum or minimum settin
g
s.
Re
b
oun
d
d
ampin
g
force
Turn the adjusting screw in direction (a)
to increase the rebound damping
force.
Turn the adjusting screw in direction (b)
to decrease the rebound damping
force.
To set the rebound damping force, turn
the adjuster in direction (a) until it
stops, and then count the clicks in di-
rection (b).
TIP
When turning the damping force
adjuster in direction (a), the 0 click
position and the 1 click position
may be the same.
When turning the damping force
adjuster in direction (b), it may
click beyond the stated specifica-
1. Headlight beam adjusting knob
(a)
(a)
(b)
(b)
1
1. Rebound damping force adjusting screw
Re
b
oun
d
d
ampin
g
settin
g
:
Minimum (soft):
31 click(s) in direction (b)
Standard:
17 click(s) in direction (b)
Maximum (hard):
0 click(s) in direction (b)
1
(b)
(a)
UBW3E0E0.book Page 21 Friday, May 24, 2019 11:01 AM
