Yamaha XSR900 2022, Service Manual

Page: 620 / 726

9-214
P0914
EAS20417
P0914
EAS32837
TROUBLESHOOTING
Item
Gear position sensor: signal stuck and sensor signal does not change.
Fail-safe system
• Able to start engine
• Able to drive vehicle
Procedure
TIP
• If more than one DTC is detected at the same time, perform troubleshooting of DTC listed below first.
• P0335, P0500, P0915, P0916, P0917, P1500
1. Installed condition of gear position sensor.
• Check for looseness or pinching.
Refer to “CRANKCASE” on page 5-64.
2. Defective gear position sensor.
• Disconnect the ECU coupler “1”.
• Measure the gear position sensor resistance.
• Shift the transmission to each position.
Is check result OK?
YES
→
Go to step 2.
NO
a. Reinstall or replace the sensor.
Refer to “CRANKCASE” on page 5-64.
b. Make sure that the position of each gear is correctly displayed on the meter.
Is check result OK?
YES
→
Go to step 4, and complete the service.
NO
→
Go to step 2.
ECU coupler “1” green/white–black/blue
Gy L L V P P/W Lg/L O/W Y/L L/B
B/L B/L Br/W Gy/G G/L Br/L B/Y L/W
W/Y W/G G/W G/W Lg/B L/W L/Y
1