Operation an
d
important ri
d
in
g
points
6-2
6
a warnin
g
or in
d
icator li
g
ht remains
on, see pa
g
e 4-3 for the correspon
d
-
in
g
warnin
g
an
d
in
d
icator li
g
ht cir-
cuit check.
The ABS warning light should
come on when the key is turned to
“ON”, and then go off after travel-
ing at a speed of 10 km/h (6 mi/h)
or higher.
NOTICE
ECA17682
If the ABS warnin
g
li
g
ht
d
oes not
come on an
d
then
g
o off as ex-
plaine
d
a
b
ove, see pa
g
e 4-3 for the
warnin
g
li
g
ht circuit check.
2. Shift the transmission into the
neutral position. The neutral indi-
cator light should come on. If not,
ask a Yamaha dealer to check the
electrical circuit.
3. Start the engine by sliding the
switch toward “
”.
If the engine fails to start, release
the start/engine stop switch, wait
a few seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the en-
gine more than 10 seconds on any
one attempt.
NOTICE
ECA11043
For maximum en
g
ine life, never ac-
celerate har
d
when the en
g
ine is
col
d
!
EAU16674
Shiftin
g
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
TIP
To shift the transmission into the neu-
tral position (
), press the shift pedal
down repeatedly until it reaches the
end of its travel, and then slightly raise
it.
1. Gear positions
2. Shift pedal
1
2
3
4
5
6
N
1
2
UBAEE0E0.book Page 2 Tuesday, December 10, 2019 2:42 PM
