Yamaha XMAX 300, Owner'S Manual

Page: 52 / 110

Instrument an d control functions
5-23
5
EAU14895
A d justin g the shock a b sor b er
assem b lies
WARNING
EWA10211
Always a d just b oth shock a b sor b er
assem b lies equally, otherwise poor
han d lin g an d loss of sta b ility may re-
sult.
Each shock absorber assembly is
equipped with a spring preload adjust-
ing ring.
NOTICE
ECA10102
To avoi d d ama g in g the mechanism,
d o not attempt to turn b eyon d the
maximum or minimum settin g s.
Adjust the spring preload as follows.
Turn the adjusting ring in direction (a)
to increase the spring preload.
Turn the adjusting ring in direction (b)
to decrease the spring preload.

Align the appropriate notch in the
adjusting ring with the position in-
dicator on the shock absorber.

Use the spring preload adjusting
tool included in the tool kit to
make this adjustment.
EAU78213
Auxiliary DC jack
WARNING
EWA14361
To prevent electrical shock or short-
circuitin
g , make sure that the cap is
installe d when the auxiliary DC jack
is not b ein g use d .
NOTICE
ECA15432
The accessory connecte d to the
auxiliary DC jack shoul d not b e use d
with the en g ine turne d off, an d the
loa d must never excee d 12 W (1 A),
otherwise the fuse may b low or the
b attery may d ischar g e.
This vehicle is equipped with an auxil-
iary DC jack located within storage
compartment A.
A 12-V accessory connected to the
auxiliary DC jack can be used when the
main switch is in the “ON” position and
should only be used when the engine is
running.
To use the auxiliary DC jack
1. Open storage compartment A.
(See page 4-8.)
1. Spring preload adjusting ring
2. Special wrench
3. Position indicator
Sprin g preloa d settin g :
Minimum (soft):
1
Standard:
3
Maximum (hard):
5
1
2
3
4
5
2
1 (a)
(b)
3
UB5X20E0.book Page 23 Tuesday, March 24, 2020 3:36 PM