INSTRUMENT AND CONTROL FUNCTIONS
3-7
3
NOTE:
This fuel meter is equipped with a self-
diagnosis system. If the electrical circuit
is defective, the display segments and
symbol “
” will flash. If this occurs,
have a Yamaha dealer check the elec-
trical circuit.
Clock mode
To set the clock:
1. Turn the key to “ON”.
2. Push the “SELECT” button and
“RESET” button together for at
least two seconds.
3. When the hour digits start flashing,
push the “RESET” button to set the
hours.
4. Push the “SELECT” button, and
the minute digits will start flashing.
5. Push the “RESET” button to set
the minutes.
6. Push the “SELECT” button and
then release it to start the clock.
EAU12344
Handlebar switches
Left
Right
EAU12360
Pass switch “PASS”
Press this switch to flash the headlight.
EAU12400
Dimmer switch “
/
”
Set this switch to “
” for the high
beam and to “
” for the low beam.
EAU12460
Turn signal switch “
/
”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “
”. When re-
leased, the switch returns to the center
1. Pass switch “PASS”
2. Dimmer switch “
/
”
3. Hazard switch “
”
4. Turn signal switch “
/
”
5. Horn switch “
”
1. Engine stop switch “
/
”
2. Start switch “
”
U5WM23E0.book Page 7 Tuesday, August 30, 2005 4:24 PM
ProCarManuals.com
