Mouthpiece (detachable).
Bkey
key
A
A key
Gkey
G
key
Low B key
Whole tone up key
Semitone up key
Fkey
Ekey
F key
Dkey
key
D
Ckey
Lip/Wind controls (four rotary pots, under cover).
Refer to the ADJUSTING THE PLAYING RE-
SPONSE section for details.
DIP switches (eight, under cover).
Refer to THE DIP SWITCHES section for details.
Lip and Wind Sensors/Dip Switches Cover
A soft rubber cover protects the adjustment controls and
switches from damage or accidental changes. To get
at the controls, pull the top part of the cover away from
the instrument, but do not take it completely off. A small
knob at the bottom allows you to pivot the cover and
use the controls, yet still keeps it safely attached to the
WX7.
WX7/Power Pack ring
Connect this ring to the hook on the MIDI/Power Pack
to keep it and the WX7 together when not playmg.
Octave Transpose keys.
Normally played with the left thumb, these keys allow
transpositon of the played note, in the following order
(reading from top to bottom): three octaves up (a); two
octaves up (b); one octave up (c); a zero notch (d) in
which to rest the thumb for playing in concert pitch; one
octave down (e); two octaves down (f).
4
Playing strap ring
Attach the playing strap to this ring to hang the WX7
from your body while playing.
Pitch Bend Wheel.
Operated by the right thumb, this allows you to bend
the pitch of notes, by an amount corresponding to the
pitch bend range setting on the connected MIDI sound
source.
Hold Key.
Allows one note to be held while other notes are played.
Refer to the PLAYING THE WX7 section for details.
Program Change key.
Permits selection of programs (on the connected MIDI
sound source) from the WX7. To change programs, hold
down the Program Change key and press an Octave
Transpose key. The top Octave Transpose key (a) cor-
responds to program number 1 on your tone generator,
the next Octave Transpose key (b) corresponds to pro-
gram 2, and so on down to the bottom Octave Transpose
key
(0,
which corresponds to program 5.
MIDI/DC connector.
For connection of the WX7 to its MIDI/Power Pack.
This connector has two functions: to supply DC power
to the WX7, and to transmit MIDI data from the WX7.
Drain Hole.
For drainage of condensation from the WX7.