Yamaha WR250F 2023, Owner'S Manual

Page: 97 / 176

REAR WHEEL
4-5
EAM20096
REAR WHEEL
EAM30022
REMOVING THE REAR WHEEL
1. Use a maintenance stand to raise the rear
wheel off the ground.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
•
Rear wheel axle nut “1”
3. Loosen:
•
Locknut “2”
4. Tighten:
•
Adjusting bolt “3”
5. Remove:
•
Rear wheel axle
• Rear wheel
TIP
•
Push the rear wheel forward and remove the
drive chain from the rear wheel sprocket.
•
Do not depress the brake pedal with the rear
wheel removed.
EAM30025
CHECKING AND REPLACING THE REAR
WHEEL SPROCKET
1. Check:
•
Rear wheel sprocket
More than 1/4 tooth wear “a”

Replace the
rear wheel sprocket and the drive sprocket as
a set.
Bent tooth

Replace the rear wheel sprock-
et and the drive sprocket as a set.
2. Replace:
•
Rear wheel sprocket
a. Remove the self-locking nuts and the rear
wheel sprocket.
b. Clean the rear wheel drive hub with a
clean cloth, especially the surfaces that
contact the sprocket.
c. Install the new rear wheel sprocket.
TIP
Tighten the self-locking nuts in stages and in a
crisscross pattern.
EAM30027
INSTALLING THE REAR WHEEL
1. Install:
•
Rear wheel
TIP
Install the brake disc “1” between the brake pads
“2” correctly.
2. Install:
•
Drive chain “1”
TIP
Push the rear wheel “2” forward and install the
3
1
2
b. Correct
1. Drive chain roller
2. Rear wheel sprocket
Rear wheel sprocket self-locking
nut
50 N·m (5.0 kgf·m, 37 lb·ft)
T
R
.
.