Yamaha WR250F 2022, Owner'S Service Manual

Page: 216 / 404

CAMSHAFT
5-15
EAM30080
REMOVING THE CAMSHAFT
1. Remove:
•
Timing mark accessing screw “1”
• Crankshaft end accessing screw “2”
2. Align:
• Alignment mark
a. Turn the crankshaft counterclockwise with
a wrench.
b. Align the top dead center (TDC) mark “a”
on the generator rotor with the alignment
mark “b” on the crankcase cover.
TIP
Align the alignment mark “c” on the exhaust
camshaft sprocket and the alignment mark “d”
on the intake camshaft sprocket with the edge of
the cylinder head.
3. Remove:
• Timing chain tensioner cap bolt “1”
•
Timing chain tensioner “2”
• Gasket
4. Remove:
• Bolt (camshaft cap) “1”
•
Camshaft cap “2”
• Clip “3”
TIP
•
Remove the bolts (camshaft cap) in a criss-
cross pattern, working from the outside in.
•
In order to prevent the clip from falling into the
crankcase, remove the camshaft cap.
NOTICE
ECA24610
The bolts (camshaft cap) must be removed
evenly to prevent damage to the cylinder
head, camshafts or camshaft caps.
5. Remove:
•
Exhaust camshaft “1”
• Intake camshaft “2”
TIP
Attach a wire “3” to the timing chain to prevent it
from falling into the crankcase.
1
2
b
a
d c
2 2 2
1 1
2 2 2
1 1
3