Yamaha WOLVERINE RMAX2 2024, Owner'S Manual

Page: 168 / 196

9-53
9
the battery, the main switch must be
off, and the positive lead must be con-
nected before the negative lead.
[ECB01111]
3. Install the battery holding plate by install-
ing the bolts.
4. Install the hood.
TIP

Make sure the battery leads are installed as
shown.

Fully charge the battery before installing it.
EBU32651
Jump-starting
Jump-starting the vehicle should be avoided.
The battery should be removed and charged
instead.
However, if the vehicle must be jump-started,
proceed as follows.
WARNING
EWB03430
To avoid battery explosion and/or serious
damage to the electrical system:

Do not connect the negative lead of the
jumper cable to the negative terminal of
the battery.

Do not touch the positive lead of the
jumper cable to the negative lead.

Do not reverse the polarity of the jumper
cables when connecting to the batteries.
1. Turn the key to “ ” (off).
2. Remove the hood. (See page 9-10.)
3. Using a charged 12-volt battery, connect
the positive lead of the jumper cable to
the positive terminal of the battery in the
1. Positive battery lead (red)
2. Negative battery lead (black)
2
1
UD2670E0.book Page 53 Tuesday, April 25, 2023 1:24 PM