Yamaha waverunner xlt800, Service Manual

Page: 60 / 499

3-1
INSP
ADJ
E
MAINTENANCE INTERVAL CHART
MAINTENANCE INTERVAL CHART
The following chart should be considered strictly as a guide to general maintenance intervals.
Depending on operating conditions, the intervals of maintenance should be changed.
*1: After every ride
*2: Inspect fluid level before every ride
*3: Grease capacity 33.0–35.0 cm
3
(1.11–1.18 oz)
*4: Grease capacity 6.0–8.0 cm
3
(0.20–0.27 oz)
Item Remarks
Initial Every
Refer to
page
10 hours
(Break-in)
50 hours
(3 months)
100 hours
(6 months)
200 hours
(1 year)
CONTROL SYSTEM
Steering cable Inspect/adjust 3-2
Steering master Inspect 3-2
Throttle cable Inspect/adjust 3-3
Carburetor throttle shaft Inspect/adjust —
Choke cable Inspect/adjust 3-4
Shift cable Inspect/adjust 3-6
QSTS cable Inspect/adjust 3-4
YPVS cable Inspect/adjust 3-7
FUEL SYSTEM
Fuel tank Clean 4-10
Fuel filter Clean/replace 3-8
Fuel line Inspect 3-8
Trolling speed Check/adjust 3-9
Carburetor setting Inspect/adjust 4-16
OIL INJECTION SYSTEM
Oil injection system Check/clean 3-10
Oil pump cable Inspect/adjust 4-29
POWER UNIT
Spark plugs Inspect/clean/adjust 3-10
Cooling water passage Inspect/clean
*1
—
Rubber coupling Inspect —
ELECTRICAL
Battery Inspect
*2
3-11
JET PUMP UNIT
Impeller Inspect 3-14
Water inlet strainer Clean 3-15
Bilge strainer Clean 3-15
GENERAL
Bolts and nuts Retighten —
Drain plugs Inspect/replace 3-15
Lubrication points Grease 3-16
Intermediate housing Grease
*3 *4
3-18