Instrument operation
38
EJU43760
Multifunction information
center
The multifunction information center displays
various watercraft information.
Multifunction information center initial op-
eration
When the multifunction information center is
activated, all of the display segments come
on. After 2 seconds, the warning indicators in
the information display go off, and then the
center starts to operate normally.
If only the multifunction information center is
activated, the “WARNING” indicator light
blinks once.
TIP:
The “UNLOCK” indicator light also comes on
as part of the initial operation.
The “UNLOCK” indicator light will go off
when the engine is started.
Multifunction information center standby
state
If the multifunction information center does
not receive any operation input within 25 sec-
onds after the engine stops, the center will
turn off and enter a standby state. When the
engine is started again, the displays return to
their state before the center turned off, and
then the center starts to operate normally.
EJU35027
Information display
The information display shows watercraft op-
erating conditions.
EJU43832
Speedometer
The speedometer shows the watercraft
speed against water.
By switching the display units, the speed can
be shown in kilometers per hour “km/h” or
miles per hour “MPH”.
1
“UNLOCK” indicator light
2
Information display
3
“L-MODE” indicator light
4
“WARNING” indicator light
1
2
3
4
1
Tachometer
2
Speedometer
3
Oil pressure warning indicator
4
Engine overheat warning indicator
5
Check engine warning indicator
6
Shift indicator
7
Fuel level warning indicator
8
Fuel level meter
1
Speedometer
1
2
3 4 5
7
6
8
1
UF4E74E0.book Page 38 Wednesday, July 17, 2019 4:26 PM
