CHAPTER FOURTEEN
FRAME
SEATS
Removal/Installation
Refer to
Figure 1
.
1. Remove the passenger seat nut (A,
Figure 2
)
from the fender stud.
2. Pull the passenger seat rearward (B,
Figure 2
)
until the seat tang disengages from the seat bracket
(A,
Figure 3
), and remove the passenger seat.
3. On XVS1100 models, perform the following:
a. Remove the seat bracket bolts and remove the
seat bracket (A,
Figure 3
).
b. Pull the rider’s seat rearward until the seat
tangs disengage from the fuel tank bracket
(
Figure 4
), and remove the seat.
4. On XVS1100A models, perform the following:
a. Remove the seat bolt (B,
Figure 3
) from the
rider’s seat.
b. Pull the riders seat rearward until the seat
tangs disengage from the fuel tank bracket
(
Figure 4
), and remove the seat.
c. If necessary, remove the seat bracket bolts
and remove the seat bracket (A,
Figure 3
).
5. Installation is the reverse of removal.
a. Slide the rider’s seat forward until its tangs
(
Figure 5
) engage the tank bracket.
b. Torque the seat bracket bolts to 7 N•m (62
in.-lb.).
c. Torque the rider’s seat bolt to 7 N•m (62
in.-lb.) on models so equipped.
d. Slide the passenger seat forward until its tang
(
Figure 6
) engages the seat bracket (B,
Fig-
ure 3
).
e. Torque the passenger seat nut to 7 N•m (62
in.-lb.).
IGNITOR PANEL
Removal/Installation
1. Remove the rider and passenger seats as de-
scribed in this chapter.
2. Remove the fuel tank as described in Chapter
Eight.
3. Release each push pin (A,
Figure 7
) by pressing
the center pin.
4. Remove the push pins and lift the ignitor panel
(B,
Figure 7
) from the frame.
5. Set the ignitor plate onto the frame.
6. Install each push pin as follows:
a. From the locking side of the fastener, push the
center pin until it extends out from the fas-
tener head.
b. Insert the push pin through the panel and
frame mounts.
14
