15
●
Using two or more UX96s
Follow the steps below to connect two or more UX96s. You do not need to re-
install the driver.
1.
Start the computer.
2.
Use the included USB cable to connect the USB terminal of the computer (or
the USB hub) to the USB terminal of the UX96.
When you turn on the power to connected multiple UX96s, the device number is
assigned, starting with 0, to the units in the order in which you turn on the power. If
you turn on the power to all units simultaneously, the device number is assigned
based on the order of the port numbers of the USB hub. However, this order may
change depending on the hub.
Macintosh users:
First install OMS before you install the USB-MIDI driver. Also, after installing the
driver, you will need to set up OMS (page 17).
●
Installing OMS
1.
Start the computer.
2.
Insert the included CD-ROM into the CD-ROM drive. The system displays the
CD-ROM icon on the desktop.
3.
Double-click to open the CD-ROM icon and double-click the “Install OMS
2.3.6” icon in the “OMS 2.3.6” folder inside “OMS E.”
Follow the instructions on the screen to install OMS. For more information on
installing and using OMS, refer to the included “OMS_2.3_Mac.pdf” manual.
●
Installing the USB-MIDI driver
1.
Start the computer.
2.
Insert the included CD-ROM into the CD-ROM drive. The system displays the
CD-ROM icon on the desktop.
NOTE
