Tyros5 Owner’s Manual
93
9
M
ixing Console
– Editi
ng the V
o
lume and
To
nal Balance
–
3
Use the TAB [
][
] buttons to call up the desired page.
For details about each page, refer to the Reference Manual on the website.
•
VOL/VOICE
.......Changes the Voice for each part and adjusts panning and
volume for each part.
•
FILTER
...............Adjusts the Harmonic Content (resonance) and sound
brightness.
•
TUNE
...................Pitch-related settings (tuning, transpose, etc.).
•
EFFECT
..............Selects effect type and adjusts its depth for each part.
•
EQ
........................Adjusts equalization parameters to correct the tone or timbre
of the sound.
•
CMP
.....................This is the Master Compressor setting which determines the
dynamics of the overall sound. See page 94.
•
LINE OUT
..........You can specify the output of each part to any of the LINE
OUT jacks. For Drum Parts, you can even select specific
instruments to be output through any LINE OUT jack.
4
Use the [A]–[J] buttons to select a parameter, then use the [1]–
[8] sliders/buttons to set the value for each part.
5
Save your Mixing Console settings.
• To save the PANEL display settings:
Register them to Registration Memory (page 85).
• To save the STYLE display settings:
Save them as Style data. If you want to recall the settings for future use, select
the Style file saved here.
1
Call up the operation display.
[CREATOR]
[B] STYLE CREATOR
2
Press the [EXIT] button to close the RECORD display.
3
Press the [I] (SAVE) button to call up the Style Selection display, then save
it (page 29).
• To save the SONG CH 1–8/9–16 display settings:
First register the edited settings as part of the Song data (SETUP), then save the
Song. If you want to recall the settings for future use, select the Song file saved
here.
1
Call up the operation display.
[CREATOR]
[A] SONG CREATOR
2
Use the TAB [
][
] buttons to select the CHANNEL page.
3
Use the [A]/[B] buttons to select “SETUP.”
4
Press the [D] (EXECUTE) button.
5
Press the [I] button to call up the Song Selection display, then save it
(page 29).
The Master Compressor is not applied
to audio playback or the Metronome
sound.
NOTE
To reset each parameter to the default
value, press the [
] and [
] of the
corresponding button ([1]–[8]) simulta-
neously.
You can instantly set the same parame-
ter value to all, if you simultaneously
hold down one of the [A]–[J] buttons
and use the [1
]–[8
] buttons
(or the DATA ENTRY dial).
NOTE
NOTE
Summary of Contents for Tyros5-76
Page 122: ...122 Tyros5 Owner s Manual MEMO...
Page 123: ...Tyros5 Owner s Manual 123 MEMO...
Page 124: ...124 Tyros5 Owner s Manual...
