Tyros4 Owner’s Manual
73
6
Re
gis
tratio
n Me
mor
y –
Saving a
nd
Recalli
ng Custom Panel
Setups –
4
Press one of the REGISTRATION MEMORY [1]–[8] buttons to
which you wish to memorize the panel setup.
The memorized button becomes red, which indicates the number button contains
data and its number is selected.
5
Register various panel setups to other buttons by repeating
steps 1–4.
The registered panel setups can be recalled by simply pressing the desired number
button.
You can save all the eight registered panel setups as a single Registration Memory Bank file.
1
Press the REGIST BANK [+] and [-] buttons simultaneously to
call up the Registration Bank Selection Display.
2
Press the [6
] (SAVE) button to save the Bank file (page 57).
If you select the button whose
lamp is lit in red or blue here, the
panel setup previously memo-
rized to the button will be erased
and replaced by the new settings.
NOTICE
About the lamp status
•
Red:
Data registered and currently selected
•
Blue:
Data registered but not currently selected
•
Off:
No data registered
The panel setups registered in the num-
bered buttons are preserved even when
you turn off the power. If you want to
delete all the eight current panel setups,
turn the power switch on while holding
the B5 key (right-most B key on the key-
board) or refer to page 32.
NOTE
Saving the Registration Memory as a Bank file
Bank 01
Bank 02
Bank 03
Bank 04
2
