Yamaha Tyros3, Reference Manual

Page: 94 / 130

8
8
M
ixing C
onsole – E
diting the
V
olume and
T
onal B
alance –
94
• Tyros3 Reference Manual
2
Use the [1
▲▼
]/[2
▲▼
] buttons to select the effect BLOCK.
3
Use the [3
▲▼
]/[4
▲▼
] buttons to select the part to which you want to
apply the effect.
Please note that a part cannot be selected if the selected block is REVERB,
CHORUS or DSP1.
4
Use the [5
▲▼
]/[6
▲▼
] button to select the effect CATEGORY.
5
Use the [7
▲▼
]/[8
▲▼
] button to select the effect TYPE.
6
If you want to edit the effect parameters, press the [F] button to call
up the display for editing the effect parameters.
7
If you have selected one of the DSP2–6 or 8–9 effect blocks in step 2:
You can edit its standard parameters as well as its variation parameter.
To select the standard type of parameters, press the [B] button. To select its
variation parameter, press the [E] button.
When the “Connection” parameter of
the DSP1 (selected on step 6 below) is
set to “System,” the DSP1 effect will be
applied overall to the Style and Song.
When it is set to “Insertion,” the DSP1
effect will behave as same as other DSP
blocks and be applied to only the part(s)
selected in step 3.
NOTE Effect
Block Effect-appli-
cable parts Effect characteristics
REVERB All parts Reproduces the warm ambience of playing in a
concert hall or jazz club.
CHORUS All parts Produces a rich, “fat” sound as if several parts
are being played simultaneously. In addition,
other type effects (such as reverb, delay, etc.)
can also be selected in this effect block.
DSP1 STYLE PART,
SONG CHAN-
NEL 1–16 This effect is applied only to Style/Song parts.
DSP2,
DSP3,
DSP4,
DSP5,
DSP6 RIGHT 1,
RIGHT 2,
RIGHT 3, LEFT,
SONG CHAN-
NEL 1–16 Any unused DSP blocks are automatically
assigned to the appropriate parts (channels) as
needed. One DSP block is available only for one
of the keyboard parts or Song parts.
DSP7 Microphone
sound This effect is applied to the MIC input, in addi-
tion to the Vocal Harmony effect.
DSP8,
DSP9 STYLE PART These effects are applied only to Style parts.
8
7
9
“Variation parameter” is the one which
can be turned on/off by pressing the
[VARIATION] button on the panel.
NOTE
NEXT PAGE