Yamaha TTR 125 2020, Owner'S Manual

Page: 63 / 86

Perio d ic maintenance an d a d justment
7-28
7
EAU23505
Replacin g the fuse
The fuse holder is located behind panel
B. (See page 7-6.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
WARNING! Do not
use a fuse of a hi g her ampera g e
ratin g than recommen d e d to
avoi d causin g extensive d am-
a g e to the electrical system an d
possi b ly a fire.
[EWA15132]
3. Turn the key to “ON” and turn on
the electrical circuits to check if
the devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
EAU24351
Supportin g the motorcycle
Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motorcy-
cle is in a stable and level position be-
fore starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
To service the front wheel
1. Stabilize the rear of the motorcy-
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing a
jack under the frame in front of the
rear wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
1. Main fuse
2. Spare fuse
Specifie d fuse:
10.0 A
U2PT17E0.book Page 28 Monday, March 30, 2020 2:13 PM