Yamaha TMAX XP500F 2015, Service Manual, Page: 157 / 478

FRONT WHEEL
4-26
• Front wheel
Damage/wear
→
Replace.
Refer to “CHECKING THE TIRES” on page
3-18 and “CHECKING THE WHEELS” on
page 3-18.
3. Measure:
• Radial wheel runout “1”
• Lateral wheel runout “2”
Over the specified limits
→
Replace.
4. Check:
• Wheel bearings
Front wheel turns roughly or is loose
→
Re-
place the wheel bearings.
• Oil seals
Damage/wear
→
Replace.
EAS30151
ASSEMBLING THE FRONT WHEEL
NOTICE
ECA22350
• Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the speed sensor rotor.
• Do not drop the speed sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the speed sensor ro-
tor, wipe it off immediately.
1. Install:
• Wheel bearings
• Oil seals
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Install the new wheel bearing (left side).
NOTICE
ECA20540
Do not apply pressure to the wheel bearing
inner race “1” or balls “2”. Pressure should
only be applied to the outer race “3”.
TIP
Use a socket “4” that matches the diameter of
the wheel bearing outer race.
b. Install the collar.
c. Install the new wheel bearing (right side).
TIP
Place a suitable washer “1” between the socket
“2” and the bearing so that both the inner race
“3” and outer race “4” are pressed at the same
time, and then press the bearing until the inner
race makes contact with the collar “5”.
d. Install the new oil seals
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
2. Install:
• Speed sensor rotor
Radial wheel runout limit
1.0 mm (0.04 in)
Lateral wheel runout limit
0.5 mm (0.02 in)
T
R
.
.
Speed sensor rotor bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
LOCTITE®
New
New