Instrument an
d
control functions
5-28
5
USB jack
To use the USB jack:
1. Turn off the device before plug-
ging into/unplugging from the
jack.
2. When the USB jack is not being
used, cover it with the cap.
3. Turn the accessory off.
4. If the USB jack overheats or mal-
functions, the indicator light will go
off. If this occurs, have a Yamaha
dealer check the vehicle.
Auxiliary DC connectors
This vehicle is equipped with a grip
warmer DC connector and a fog lamp
connector. Consult a Yamaha dealer
before installing any accessories.
EAU15306
Si
d
estan
d
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
EWA10242
The vehicle must not
b
e ri
dd
en with
the si
d
estan
d
d
own, or if the si
d
e-
stan
d
cannot
b
e properly move
d
up
(or
d
oes not stay up), otherwise the
si
d
estan
d
coul
d
contact the
g
roun
d
an
d
d
istract the operator, resultin
g
in a possi
b
le loss of control.
Yamaha’s i
g
nition circuit cut-off
system has
b
een
d
esi
g
ne
d
to assist
the operator in fulfillin
g
the respon-
si
b
ility of raisin
g
the si
d
estan
d
b
e-
fore startin
g
off. Therefore, check
1. USB jack cap
1
1
1. USB jack
2. USB jack indicator light
1
1
22
UBVWE0E0.book Page 28 Friday, July 14, 2023 3:12 PM
