Yamaha Tenere 700 2020, Service Manual

Page: 240 / 472

SHIFT SHAFT
5-53
EAS30377
CHECKING THE SHIFT SHAFT
1. Check:
• Shift shaft
Bends/damage/wear
→
Replace.
• Shift shaft spring
• Collar
Damage/wear
→
Replace.
EAS30378
CHECKING THE STOPPER LEVER
1. Check:
• Stopper lever
Bends/damage
→
Replace.
Roller turns roughly
→
Replace the stopper
lever.
EAS30381
INSTALLING THE SHIFT SHAFT
1. Install:
• Bearing “1”
• Oil seal “2”
TIP
• Apply engine oil onto the bearing.
• Make sure that the bearing does not protrude
past the line “b” shown in the illustration.
• Lubricate the oil seal lips with lithium-soap-
based grease.
2. Install:
• Shift shaft spring stopper
• Washer
• Shift shaft assembly
• Stopper lever spring
TIP
• Hook the end of the shift shaft spring “2” onto
the shift shaft spring stopper “1”.
• Hook the ends of the stopper lever spring “3”
onto the stopper lever “4” and the stopper lever
spring hook “5”.
• Mesh the stopper lever with the shift drum seg-
ment assembly.
Install depth “a”
0.6–1.1 mm (0.02–0.04 in)
T
R
.
.
Shift shaft spring stopper
22 N·m (2.2 kgf·m, 16 lb·ft)
LOCTITE®
New
1
b
2
a
New
1
2
5
3
4