Yamaha Tenere 700 2020, Service Manual

Page: 102 / 472

GENERAL CHASSIS (2)
4-3
EAS31264
REMOVING THE SIDE COVERS
The following procedure applies to both of the
side covers.
1. Remove:
• Side cover “1”
TIP
Remove the projections “a” on the side cover
from holes “b” on the tail cover, and then remove
the projections “c” from the grommets “d”.
EAS33139
REMOVING THE TAIL COVER
1. Remove:
• Tail cover “1”
TIP
Unhook the projection “a” on the rear fender as-
sembly from the hole “b” on tail cover.
EAS31641
REMOVING THE ECU (engine control unit)
1. Disconnect:
• ECU coupler
TIP
While pushing the projection “a” and move the
lock lever “b” of the ECU coupler in the direction
of the arrow shown in the illustration to discon-
nect the coupler.
EAS31642
INSTALLING THE ECU (engine control unit)
1. Connect:
• ECU coupler
TIP
Push the lock lever “a” of the ECU coupler in the
direction of the arrow shown in the illustration to
connect the coupler.
EAS33140
INSTALLING THE TAIL COVER
1. Install:
• Tail cover “1”
TIP
Fit the projection “a” on the rear fender assembly
into the hole “b” on the tail cover.
EAS31265
INSTALLING THE SIDE COVERS
The following procedure applies to both of the
side covers.
1. Install:
• Side cover “1”
1
c
a
b
d
1
a
b
a
b
a
1
a
b