INSTRUMENT AND CONTROL FUNCTIONS
4-6
4
The fuel level warning light comes on
and the display switches to the fuel re-
serve tripmeter mode “Trip F” when the
fuel level is very low. Refuel as soon as
possible to avoid running out of fuel.
To set the clock
1. Push the “SELECT” switch to
change the display to the clock
mode.
2. Push the “SELECT” and “RESET”
switches together for at least three
seconds.
3. When the hour digits start flashing,
push the “SELECT” switch to set
the hours.
4. Push the “RESET” switch, and the
minute digits will start flashing.
5. Push the “SELECT” switch to set
the minutes.
6. Push the “RESET” switch and then
release it to start the clock.
Self-diagnosis device
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
If a problem is detected in any of those
circuits, the engine trouble warning light
will come on and the display will indi-
cate an error code.
If the display indicates any error codes,
note the code number, and then have a
Yamaha dealer check the vehicle.
NOTICE
ECA11590
If the display indicates an error
code, the vehicle should be checked
as soon as possible in order to avoid
engine damage.
Brightness control mode
This function allows you to adjust the
brightness of the multi-function meter
unit panel to suit the outside lighting
conditions.
To set the brightness
1. Turn the key to “OFF”.
2. Push and hold the “SELECT”
switch.
1. Clock
1
1. Engine trouble warning light “
”
2. Error code display
1
2
1. Brightness level
1
U27D12E0.book Page 6 Wednesday, May 9, 2012 3:31 PM
