background image

3

Connecting the Speakers

CONNECTION EXAMPLE

The illustration below shows audio connections for a standard setup using two speaker systems.

MIXING

CONSOLE

GRAPHIC

EQUALIZER

SPEAKER
SYSTEMS

L

R

L

R

SPEAKER
SYSTEMS

DAISY-CHAINED

POWER

AMPLIFIER

L

R

DAISY-CHAINING SPEAKERS

Since the speaker systems in this series are equipped with two input terminals that are internally connected in parallel, it is

possible “daisy-chain” speakers by connecting the output from the power amplifier to one phone jack, and a second speaker

system to the other.

All speaker models in this series have a nominal impedance of 8

. Since most power amplifiers are designed to provide stable

performance at a load impedance of 4 or 8

, Yamaha recommends that no more than two 8

 speaker systems be daisy-chained

together. This will allow the amplifier to operate properly and avoid overheating.

CAUTION!

For the four models, S10e, S12e, S15e and S12Me, use the

TS-30, TS-40, TS-80, or TS-90 speaker stand by Ultimate

Support System, Inc. sold separately.

When using speaker stands, observe the following precau-

tions to prevent the speaker stands from falling over or the

speaker system being dropped.

• Use the speaker stands with their legs fully opened.

• Do not place more than one speaker on the same speaker

stand.

• Tighten fastening screws securely.

• Remove the speakers from the stands before moving the

stands or adjusting their height.

• Implement measures to prevent the speaker stands from

falling over.

• Use the stand at no higher than 150 cm for all speaker

models.

• The top tube of the TS-30 and TS-40 speaker stands has

a diameter of 1-1/2", but is tapered to 1-3/8" at the top to

fit in the mounting holes on the four models named. If

you should remove the top tube from a stand, be sure to

insert it with the narrow end up when reassembling.

Summary of Contents for S10e

Page 1: ...nstrucciónes Thank you for purchasing a YAMAHA product To obtain maximum performance from your YAMAHA speaker system and ensure many years of trouble free operation we recommend that you read this Owner s Manual thoroughly before use Contents Precautions 2 Connecting the Speakers 3 Specifications 4 ...

Page 2: ...NG OR REMOVING CONNECTIONS Always turn the power switches of system components OFF prior to connecting or disconnecting cables Failure to do so may result in damage to speakers as well as to con nected equipment DISCONNECT CABLES BEFORE MOVING THE SYS TEM To prevent short circuits or breakage of cables always dis connect cables prior to moving system equipment MATCH CONNECTOR POLARITY When using t...

Page 3: ...ill allow the amplifier to operate properly and avoid overheating CAUTION For the four models S10e S12e S15e and S12Me use the TS 30 TS 40 TS 80 or TS 90 speaker stand by Ultimate Support System Inc sold separately When using speaker stands observe the following precau tions to prevent the speaker stands from falling over or the speaker system being dropped Use the speaker stands with their legs f...

Page 4: ... input Dimensions W x H x D 397 x 550 x 326 mm S12e 405 x 580 x 337 mm 486 x 667 x 367 mm S12Me 570 x 410 x 318 mm Weight 13 8 kg S12e 15 kg 20 3 kg S12Me 13 8 kg Specifications Unit mm EIA RS 426 Specifications subject to change without notice PHONE PLUG WIRING The standard input terminals for this unit are 1 4 phone jacks Connect the speaker leads as shown in this diagram Caution Use only unshie...

Reviews: