Working with the Library
45
SREV1—Owner’s Manual
Working with the Library
This section explains how to load, save, title, protect, and delete programs from the
Internal Card, PC Card, and CD-ROM. These operations are carried out on the Library
pages shown below. In 2-channel x2 mode, two Library pages are available: Library-A
and Library-B. In the program list, a dotted box highlights the selected program. In the
DRIVE section of the page, INTERNAL is the Internal Card, CD-ROM is the CD-ROM
drive, and PCMCIA is the PC Card.
Loading Programs from the Library
Programs can be loaded from the following drives: Internal Card, PC Card, or
CD-ROM. The loaded program becomes the current program. The preset programs on
the supplied CD-ROM are loaded into the Internal Card at the factory.
1
Use the [PROGRAM] button to locate the Library page.
2
Use the cursor buttons to select a drive button, and then press [ENTER] to
make it the active drive.
The programs stored on the active drive appear in the program list.
3
Use the DATA wheel or the [–1/DEC] and [+1/INC] buttons to select a program
from the list.
4
Use the cursor buttons to select the LOAD button, and then press [ENTER].
If the current program contains unsaved changes, a warning message appears. Select
YES to discard the changes and load the selected program, or select NO to cancel the
operation.
The selected program, and its impulse-response data, is loaded and its title appears on
the display.
2-ch mode
4-ch mode
2-ch x2 mode—A
2-ch x2 mode—B
