Yamaha S-03SL, Owner'S Manual

Page: 59 / 112

59
Multi Mode
21. AC1VarCtl
(AC1 Variation Effect Control Depth)
This determines the degree to which the Assignable
Controller 1 controls the Variation Effect.
❏
Settings : –64~+63
n
This can be set only when Variation Connection (above)
is set to “INS.” When Variation Connection is set to
“SYS,” “***” appears in the display and the setting
cannot be changed.
n
The particular parameter that can be controlled with the
Assignable Controller 1 is fixed for each of the Variation
effects. Refer to the separate Data List for details.
n
For information on the AC1, refer to AC1 CC No (pages
66 and 92 ) in the Multi and Utility modes.
Part
(Settings for each Part)
The following is an explanation of the Part parameters
used to edit each Multi.
n
Refer to the Function Tree chart (page 20) or the
Parameter Table (page 22).
Voice Selection (PAGE 1)
Part Mix (PAGES 2 to 5)
Part General (PAGES 6 to 9)
Part Tone (PAGES 10 to 14)
Part Controller (PAGES 15 to 21)
Part Effect (PAGES 22 to 24)
1. Voice Selection
You can assign a Voice to each Part. Use the [+] and [–]
buttons to select the Part, then select its Voice. The
display will vary as follows according to the Memory
selected.
n
Specify the particular Voice Memory by pressing the
appropriate Memory button: PRESET, USER or GM/XG.
n
To select a Drum Voice, simultaneously hold down the
[DRUM] button and press the appropriate Memory
button: [USER] or [GM/XG].
n
The Voice can be set by using the same method as with
Category Search (page 35).
n
For details about Categories, refer to the Category List on
page 71. For details about using Category Search, see
page 35.
●
PRESET
❏
Settings : PR001 ~ PR128
AC1VarCtl
+00
KEY ELEM PART
OCTAVE
PAGE
21
StPiano1
PR001
KEY ELEM PART
OCTAVE
PAGE
1
Common Effect/Voice Selection