Yamaha RX-V775, Owner'S Manual

Page: 21 / 139

PREPARATIONS
➤
Connecting speakers
En
21
Push-type speaker terminals
(RX-V675 only)
a
Remove approximately 10 mm (3/8”) of insulation from
the ends of the speaker cable, and twist the bare wires of
the cable firmly together.
b
Press down the tab.
c
Insert the bare wires of the cable into the hole in the
terminal.
d
Release the tab.
■
Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
Connecting front speakers that
support bi-amp connections
When using front speakers that support bi-amp
connections, connect them to the FRONT jacks and
SURROUND BACK/BI-AMP jacks.
To enable the bi-amp function, set “Power Amp Assign”
(p.91) in the “Setup” menu to “5ch BI-AMP” after
connecting the power cable to an AC wall outlet.
• The FRONT jacks and SURROUND BACK/BI-AMP/ZONE B jacks
output the same signals.
ZONE 2/F
.PRESENCE
EX
TRA SP
a a
b
c
d
+ (red)
- (black)
Audio pin cable
1 2
3
4 5
9
FRONT CENTER S URROUND
S INGLE
S URROUND BACK/BI-AMP
S PEAKER S
S UBWOOFER
CENTER
ZONE2/F.PRE S ENCE
EXTRA S P
CENTER
1
2
The unit (rear)
Caution
• Before making bi-amp connections, remove any brackets or
cables that connect a woofer with a tweeter. Refer to the
instruction manual of the speakers for details. If you are not
making bi-amp connections, make sure that the brackets or
cables are connected before connecting the speaker cables.
• Surround back speakers cannot be used during bi-amp
connections.
1 2
Speaker connections
3 4 5 6 7 8 9 10