56
SYSTEM OPTIONS
Use this feature to reassign digital input/outputs, select the
input signal, rename the inputs, or adjust the level of the
signal input at each jack.
1
Set AMP/SOURCE/TV to AMP, then press
TOP on the remote control.
2
Select Input Select, then press
h
.
3
Select the desired input (CD, DVD, etc.), then
press
h
to access and adjust.
■
I/O Assignment
(Input/output assignment)
You can assign the digital audio input/output and
component video jacks to other components if this unit’s
initial settings do not correspond to your needs. Change
the following parameters to reassign the jacks and
effectively connect more components.
Once the jacks are reassigned, you can select the
corresponding component using the INPUT selector on
the front panel or the input selector buttons on the remote
control.
Input Select > input source (DVD, etc.) >
I/O Assignment >
Example 1:
To assign the COAXIAL
7
(CD) jack to the DVD input.
1) Select Input Select, then select DVD.
2) Select I/O Assignment > Coaxial Input, then select
7
CD.
Example 2:
To clear a jack assignment.
1) Select Input Select, then select the input source (DVD,
etc.).
2) Select I/O Assignment, then select the jack assignment
(Optical Output, Optical Input, Coaxial Input or
Component Video).
3) Select NONE, then press ENTER to clear the
assignment.
y
This menu item is also available in the front panel display system
options menu (see page 90).
• You cannot select a specific item more than once for the same
type of jack.
• When you connect a component to both the COAXIAL and
OPTICAL jacks, priority is given to signals input at the
COAXIAL jack.
Input Select
TOP
TITLE
AMP
SOURCE
TV
MD/TAPE
CD-R
DTV
CBL/SAT
DVD
Input Select
Manual Setup
Auto Setup
Stereo/Surround
Notes
Optical Input
Coaxial Input
Optical Output
I/O Assignment
Audio Select
Decoder Mode
