En
63
APPENDIX
Troubleshooting
HDMI™
Tuner (FM/AM)
FM
Problem
Cause
Remedy
See
page
The front panel
display HDMI
indicator is flashing.
An error with the HDMI
connection has occurred.
Try re-inserting the HDMI cable.
—
Confirm that HDMI video that is not
supported by the unit is not being input
(HDMI Input
→
Option menu
→
“Signal
Info”).
No picture or sound.
The number of components is over
the limit.
Disconnect some of the HDMI components.
—
The connected HDMI component
does not support high-bandwidth
digital copyright protection
(HDCP).
Connect an HDMI component that supports
HDCP.
—
(When using HDMI
Control function)
TV sound is not
output from this unit
when operating the
remote control of the
TV.
The TV audio output is not
connected to this unit, or the
setting to match operations carried
out on TV is not set.
Connect the TV audio output to this unit,
and then select the connected input source
in “TVAudio” (Setup menu
→
HDMI Setup
→
TVAudio).
(When using Audio Return
Channel function)
The Audio Return Channel
function is not working.
Make sure that your TV supports Audio
Return Channel.
Set the Audio Return Channel function to
on (Setup menu
→
HDMI Setup
→
ARC).
Problem
Cause
Remedy
See
page
FM stereo reception
is noisy.
You are too far from the station
transmitter, or the input from the
antenna is weak.
Check the antenna connections.
Switch to monaural mode.
Replace the outdoor antenna with a more
sensitive multi-element antenna.
—
There is distortion,
and clear reception
cannot be obtained
even with a good FM
antenna.
There is multi-path interference.
Adjust the antenna height or orientation, or
place it in a different location.
—
The desired station
cannot be tuned into
with the automatic
tuning method.
You are in an area far from a
station, or input from the antenna
is weak.
Replace the outdoor antenna with a more
sensitive multi element antenna.
—
Use
e
TUNING
H
/
I
(on the remote
control) to manually select the station.
“No Presets” is
displayed.
No preset stations are registered.
Register stations you wish to listen to as
preset stations before operation.
“Wrong Station” is
displayed.
An invalid FM/AM frequency has
been input.
Input a frequency that can be received.
—
