En
21
Basic speaker configuration
If you do not apply bi-amp connections, channel expansion (using an external amplifier) or multi-zone configurations, follow the procedure below to place the speakers in your room and connect
them to the unit.
■
Placing speakers in your room
Depending on the number of speakers, place the speakers and subwoofer in your room. This
section describes the representative speaker layout examples.
X
• To have a full effect of Dolby Atmos contents, we recommend using a speaker system with a
S
mark. However,
you can also play back Dolby Atmos contents with the 7.1 system (using surround back speakers).
• To have a full effect of DTS:X contents, we recommend using a speaker system with a
S
mark.
• (About the number of channels) For example, “5.1.2” denotes “standard 5.1-channel plus 2 for overhead
speaker channels”. For details on how to place overhead speakers (presence speakers), see “Presence speaker
7.2.2/5.2.4 system [
S
]
(using both surround back and rear presence speakers)
This speaker system brings out the full performance of the unit and allows you to enjoy a
highly-natural 3-dimensional sound field with any contents.
X
• The surround back speakers and rear presence speakers do not produce sounds simultaneously. The unit
automatically changes the speakers to be used, depending on the input signal and CINEMA DSP (p.76).
• When using front presence and rear presence speakers installed to the ceiling or when using the Dolby Enabled
speakers as the presence speakers, configure the “Layout (Front Presence/Rear Presence)” setting in the
“Setup” menu before performing YPAO (p.53).
• (RX-V3085 only)
By using an external power amplifier (p.31), you can make an 11-channel system [
★
7.2.4] and enjoy Dolby
Atmos and DTS:X contents with the front presence and rear presence speakers.
E
9
R
1
2
3
9
4
5
6
7
T
Y
