En
150
■
Input Assignment
Assigns the COMPONENT VIDEO, COAXIAL and OPTICAL jacks to another input source.
Input Assignment
■
Procedure
Example: assigning the OPTICAL (
2
) jack to the input source “AV 2”
1
Use the cursor keys to select the cell at the intersection of “AV 2” and “OPTICAL”, and press
ENTER.
2
Use the cursor keys to select “
2
” and press ENTER.
3
To exit from the menu, press SETUP.
X
You cannot assign both COAXIAL and OPTICAL jacks to the same input source.
■
Input Skip
Set which input sources are skipped when operating the INPUT key or AV CONTROLLER. You
can select the desired input source quickly by using this function.
X
When using AV CONTROLLER, you cannot select the input sources set to “On” in this function.
Input sources
AV 1-7, AUX, AUDIO 1-4*, PHONO, TUNER, (network sources), Bluetooth, USB
* AUDIO 4: RX-V3085 only
Settings
■
Input Rename (Auto)
Automatically changes the input source names displayed on the front display.You can select a
name created by the Auto Rename function.
Input sources
AV 1-7, AUDIO 1-3
■
Procedure
1
Use the cursor keys to select an input source to be renamed.
2
Use the cursor keys to select “Auto”.
3
To change another input source name, repeat steps 1 to 2.
4
Press SETUP.
X
• When “Auto” is selected, the created name is saved even after the external device is disconnected. To reset to
the default setting, switch the setting to “Manual” and then back to “Auto”.
• “Auto” can be selected for AUDIO 1-3 only if a digital “Input Assignment” setting is selected.
Off
Does not skip the selected input source.
On
Skips the selected input source.
