Yamaha RX-V3085, Owner'S Manual

Page: 144 / 190

En
144
■ Network Connection
Selects the network connection method.
Settings
■ IP Address
Configures the network parameters (such as IP address).
DHCP
Select whether to use a DHCP server.
Settings
IP Address
Set the network parameters (such as IP address, Subnet Mask, and Default Gateway)
manually.
■ Manual network settings
1
Set “DHCP” to “Off”.
2
Use the cursor keys to select “IP Address” and press ENTER.
3
Use the cursor keys to select a parameter type and press ENTER.
4
Use the cursor keys to move the edit position and to select a value.
5
To confirm the setting, press ENTER.
6
To configure another network parameter, repeat steps 2 to 4.
7
To exit from the menu, press SETUP.
■ Network Standby
Selects whether the unit can be turned on from other network devices (network standby).
Settings
With an advanced energy saving design, this product achieves a low power consumption of not
more than two watts when in Network Standby mode.
Wired
Select this option when you want to connect the unit to a network with a
commercially-available network cable (p.50).
Wireless (Wi-Fi)
Select this option when you want to connect the unit to a network via the wireless
router (access point). For details on settings, see “Connecting the unit to a
wireless network” (p.67).
Off
Does not use a DHCP server. Configure the network parameters manually. For
details, see “Manual network settings”.
On
Uses a DHCP server to automatically obtain the unit’s network parameters (such
as IP address).
IP Address Specifies an IP address.
Subnet Mask Specifies a subnet mask.
Default Gateway Specifies the IP address of the default gateway.
DNS Server (P) Specifies the IP address of the primary DNS server.
DNS Server (S) Specifies the IP address of the secondary DNS server.
Off Disables the network standby function.
On
Enables the network standby function.
(The unit consumes more power than when “Off” is selected.)
Auto
Enables the network standby function.
(If “Network Connection” is set to “Wired”, the unit is set to the power saving
mode when the network cable is disconnected.)