SETUP
Setting various functions (Setup menu)
106
■
Entering standby mode
automatically when no operations
are performed
Auto Power Down
If you do not operate this unit or use the remote control
for an extended period of time, it will automatically go
into standby mode (Auto Power Down function). This
function’s default setting is “Off.” When you want to
enable this function, set the amount of time to pass
before this unit will enter standby.
■
Assigning component input and
output jacks
Input Assignment
Assigns the coaxial or optical input jack(s) to the
selected input source when this unit’s initial settings do
not correspond to your needs. Change the parameter to
reassign the respective jacks and effectively connect
more components.
Once the input jacks are reassigned, the corresponding
component can be selected using the Input selector
buttons.
Example: Assigning the OPTICAL input jack to
“AV1.”
1
Press
i
ENTER
to display the “Input
Assignment” screen.
2
Press
i
Cursor
B
/
C
/
D
/
E
to select the
cell at the intersection with the “AV1” and
“Coax/Opt” and then press
i
ENTER
.
3
Press
i
Cursor
D
/
E
to select “
c
” and then
press
i
ENTER
.
Select “None” to clear the existing assignment.
4
Press
i
RETURN
to apply change and
return to the previous screen.
RETURN
ENTER
SOURCE
RECEIVER
AV
AUDIO
4
3
1
2
7
5
6
V-AUX
4
3
1
2
USB
MULTI
NET
PHONO
TUNER
DOCK
[ B ]
[ A ]
i
4Hours
Goes into standby mode, when you have
not operated this unit for four hours.
8Hours
Goes into standby mode, when you have
not operated this unit for eight hours.
12Hours
Goes into standby mode, when you have
not operated this unit for twelve hours.
Off
(Default)
Auto Power Down function is disabled.
This unit starts a countdown of 30 seconds before
entering the standby mode. Pressing any key of the
remote control during the countdown cancels entering
the standby mode and reset the timer.
The choices indicate the following jacks.
a
,
b
,
f
: COAXIAL jacks
c
,
d
,
e
: OPTICAL jacks
,
,
,
: COMPONENT VIDEO jacks
The choices indicate the jacks marked the same
alphanumeric on the rear of this unit. For details on
marks on the rear of this unit, refer to “Rear panel”
(
•
A specific item cannot be selected more than once for
the same type of jack.
•
Only component, coaxial and optical jacks can be
reassigned.
•
Coaxial and optical jacks cannot be assigned to the
input at the same time.
