PREPARATIONS
➤
Optimizing the speaker settings automatically (YPAO)
En
40
Measuring at one listening position
(single measure)
When “Multi Position” is set to “No”, follow the procedure below for
measurement. It takes about 3 minutes to perform the
measurement.
1
To start the measurement, use the cursor keys to
select “Measure” and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
• To cancel the measurement temporarily, press RETURN.
The following screen appears on the TV when the
measurement finishes.
• If any error message (such as E-1) or warning message (such as W-1)
appears, see “Error messages” (p.44) or “Warning messages” (p.45).
• To check the measurement results, select “Result”. For details, see
“Checking the measurement results” (p.43).
2
Use the cursor keys to select “Save/Cancel” and
press ENTER.
3
To save the measurement results, use the cursor
keys (
e
/
r
) to select “SAVE” and press ENTER.
The adjusted speaker settings are applied.
• To finish the measurement without saving the result, select “CANCEL”.
4
Use the cursor keys (
e
/
r
) to select “YES” or “NO”
to enable/disable YPAO Volume and press ENTER.
• If YPAO Volume is enabled, the high- and low-frequency levels are
automatically adjusted according to the volume so that you can enjoy
natural sounds even at low volume.
• You can also enable/disable YPAO Volume in “YPAO Volume” (p.94) in the
“Option” menu.
1 2 3 4 5 6 7 8 9 10
ENTER
RETURN
Cursor keys
