CONFIGURATIONS
➤
Configuring various functions (Setup menu)
En
112
Adjusts the delay between video and audio output manually when “Auto/Manual
Select” is set to “Manual”. You can fine-adjust the audio output timing when
“Auto/Manual Select” is set to “Auto”.
Setting range
0 ms to 500 ms (1 ms increments)
• “Offset” shows the difference between automatic adjustment and fine adjustment.
■
Dynamic Range
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and
DTS signals) playback.
Settings
■
Max Volume
Sets the maximum volume to prevent excessive loudness.
Setting range
-30.0 dB to +15.0 dB (5.0 dB increments), +16.5 dB
■
Initial Volume
Sets the initial volume when the receiver is turned on.
Settings
■
Pure Direct Mode
Selects whether to output video signals during the Pure Direct mode (p.62).
Settings
■
Adaptive DSP Level
Selects whether to automatically adjust the CINEMA DSP effect level.
Settings
■
CINEMA DSP 3D Mode
Enables/disables CINEMA DSP 3D (p.58). If this function is set to “On”, CINEMA DSP
3D functions with the selected sound programs (except 2ch Stereo and 7ch Stereo).
Settings
Adjustment
Maximum
Produces audio without adjusting the dynamic range.
Standard
Optimizes the dynamic range for regular home use.
Minimum/Auto
Sets the dynamic range for clear sound even at night or at low
volumes.
When playing back Dolby TrueHD signals, the dynamic range is
automatically adjusted based on the input signal information.
Off
Sets the level to the volume level of the unit when it last entered
standby mode.
On
Sets at Mute or the specified volume level (-80 dB to +16.5 dB, 0.5 dB
increments).
(This setting works only when the initial volume is set lower than “Max
Volume”.)
Auto
Automatically outputs video signals when any videos are input from
the selected input source or an input source that can be operated with
the on-screen display is selected. When no video signals are input,
the wall paper is displayed.
Video Off
Does not output video signals including the wall paper.
Off
Does not adjust the effect level automatically.
On
Adjusts the effect level automatically according to the YPAO
measurement results and the volume level.
Off
Disables CINEMA DSP 3D.
On
Enables CINEMA DSP 3D.
